MATERIAL SAFETY DATA SHEET
(Complies with OSHA Communication Standard 29CFR 1910.1200 Dept. of Labor.)
CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Osborn 76329TM4090 Safety Solvent
Revision Date:
2/8/02MANUFACTURER/SUPPLIER'S/NAME:
Osborn International, 5401 Hamilton Ave., Cleveland, OH 44114 (330) 467-4195
COMPOSITION/INFORMATION ON INGREDIENTS
PRODUCT COMPOSITION/ ACGIH TLV OSHA PEL
CAS REG NO. WGT. % TWA STEL TWA STEL UNITS
Perchloroethylene
127-18-4
40-50 25 100 100 NA PPMIsoparaffinic Hydrocarbon
64742-48-9
20-30 50Trichloroethylene
79-01-6
20-30 100 100 200 ppmCarbon Dioxide
124-38-9
1-10 5000 30000 5000 N/A ppmAdditional Component Information:
NA
HAZARDS IDENTIFICATION
HEALTH HAZARD DATA (ACUTE AND CHRONIC)
May cause dizziness or narcosis in high vapor concentrations. Will cause defatting of skin. Effects are reversible. Long term exposure (years) to high concentrations of vapor may cause lung, liver or kidney damage. The solvents listed have been reported to affect the central nervous system. Aspiration hazard if swallowed. Eye and skin irritant. May irritate respiratory tract. Deliberately concentrating and inhaling the vapor of the contents may be harmful or fatal.
OTHER:
Eye irritation may be severe. May cause cardiac abnormalities. Perchloroethylene may cause spleen and brain damage. Trichloroethylene may cause anemia.
CARCINOGENICITY:
Perchloroethylene is listed as a carcinogen by IARC and NTP. See Regulatory Section
FIRST AID
Give oxygen. Do not induce vomiting. Wash eyes and skin with water for 15 minutes. Get medical help. Never administer adrenalin following overexposure.
ROUTES OF ENTRY
Ingestion, Inhalation, Skin
SIGNS AND SYMPTOMS OF OVEREXPOSURE_
Inhalation - Difficulty in breathing. Skin - redness. Ingestion - vomiting.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE:_
Heart Disease, Respiratory Disorders
PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point
189F to 372FVapor Pressure at 70F
85-90VAPOR DENSITY (AIR=1)
4.0EVAP. RATE(BUTYL ACETATE=1)
>1SPECIFIC GRAVITY (WATER=1) The ratio of the weight of a volume of material to the weight of an equal volume of water. Usually expressed as greater than one (>1).
1.4Solubility
NilAppearance Clear
Odor
SolventPH:
Not ApplicableSTABILITY AND REACTIVITY
STABILITY:
STABLEINCOMPATIBILITY:-
Strong oxidizers, strong alkalies reactive metalsHAZARDOUS THERMAL DECOMPOSITION/COMBUSTION PRODUCTS:- Carbon dioxide, halogen acids, phosgene.
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
REGULATORY INFORMATION
CALIFORNIA PROPOSITION 65:
WARNING: This product contains chemicals known to the State of California to cause cancer.
Ozone Depleting Substances:
None
HMIS:
FLAMMABILITY 2 , REACTIVITY 0 , HEALTH 1
NFPA:
FLAMMABILITY 2 , REACTIVITY 0 , HEALTH 2
SARA 313 TITLE III - TOXIC CHEMICALS LIST:
Perchloroethylene (127-18-4) Trichloroethylene (CAS 79-01-6)
DOT Shipping Name:
Consumer Commodity, ORM-D
CONTROL MEASURES
Respiratory Protection Equipment
Use NIOSH approved respirator if TLV limit is exceeded.
VENTILATION:
Local exhaust - yes
PROTECTIVE GLOVES:
None required if spraying.
EYE AND FACE PROTECTION:
Safety glasses.
OTHER PROTECTIVE EQUIPMENT:
Long Sleeves and Long pants
SAFE HANDLING
Do not smoke while using. Wash hands after use.
PRECAUTIONS FOR SAFE HANDLING AND USE
Flash Point
Based on Isoparaffinic Hydrocarbon 120F T C C.LOWER EXPLOSION LIMIT : 1.3
UPPER EXPLOSION LIMIT : 9.8
EXTINGUISHING MEDIA:- Water fog, carbon dioxide, foam, dry chemical
UNUSUAL FIRE AND EXPLOSION HAZARDS:-
Heated cans may burst.SPECIAL FIRE FIGHTING PROCEDURES
Keep containers cool. Use equipment or shielding required to protect against bursting or venting containers.SPILL PROCEDURES:_
Use absorbent sweeping compound to soak up material. Put into container. Dispose as hazardous waste.WASTE DISPOSAL METHODS:_
Dispose as hazardous waste in accordance with EPA RCRA.PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: This section contains precautions for general handling and storage of this particular material. This section is generally for SPBD customers; although the statements should generally apply for internal use as well. Any in-plant rules or procedures should take priority over these handling and storage precautions.
Keep away from heat, sparks, or open flame. Store at temperatures below 120F.OTHER INFORMATION:
When spraying more than one half can continuously or more than one can consecutively, use NIOSH approved respirator.NFPA 30B Level:
1